[CaptainSlow]

I just did the first drain and fill. In case you did not know, you are going to need a transfer pump, 4.5 quarts of ATF 2.0 and 3 crush washers. It is pretty easy once you have the proper tools and parts. If you look at the picture, "D" is the filler point and "A" is the level. Once you see ATF coming out of "A" you have reached the proper level. Below is a list of items needed with part numbers. I hope this helps someone and do not forget to shake it well before pumping it into the transmission.

EDIT: I forgot to mention that you need to go thru the gears "P" and "D" for at lease 3 seconds and check the level again. The car has to be level at all times.

1. Transfer pump from Harbor Freight $7.00.
2. 5 quarts of ATF Type 2.0 part # 08200-9015 $10.00 each.
3. Washer part # 90471-PX4-00 $2.00
4. Washer part # 94071-PW7-A00 $3.00
5. Washer 20 MM part # 94109-20000 $2.92

 

[Vegashybrid]

Just be careful with those harbor freight pumps. Keep it slow and maybe glue the exit tube into its slot they have a tendency of slipping out when pumping, and then you have fluid everywhere.

 

[CaptainSlow]

I did not have any issues with the pump, but like Vegashybrid said, keep it slow. I think glueing it may not be a bad idea. Then again, you don't have to use the HF one. Any transfer pump will do

 

[decovamber]

I'm getting close to 45k mi on my 2018 Acoord and I finally got the maintenance minder I've been anticipating. A3. So far I've done all the maintenance items on my accord and would like to keep doing so. I was trying to find fine info on transmission fluid change for the 10 Speed Automatic (10AT) transmission and can't find much. Does anyone know of any mechanics manuals or any guides figure the 2018 Accord or for three 10AT? I've done clutch replacements on front wheel drive manuals before, so I'm pretty confident I can handle automatic transmission fluid change, I'd just like to know the recommended procedure.

snaptube vidmate​

 

[EngTech1]

I just did the first drain and fill. In case you did not know, you are going to need a transfer pump, 4.5 quarts of ATF 2.0 and 3 crush washers. It is pretty easy once you have the proper tools and parts. If you look at the picture, "D" is the filler point and "A" is the level. Once you see ATF coming out of "A" you have reached the proper level. Below is a list of items needed with part numbers. I hope this helps someone and do not forget to shake it well before pumping it into the transmission.

EDIT: I forgot to mention that you need to go thru the gears "P" and "D" for at lease 3 seconds and check the level again. The car has to be level at all times.

1. Transfer pump from Harbor Freight $7.00.
2. 5 quarts of ATF Type 2.0 part # 08200-9015 $10.00 each.
3. Washer part # 90471-PX4-00 $2.00
4. Washer part # 94071-PW7-A00 $3.00
5. Washer 20 MM part # 94109-20000 $2.92

View attachment 5712

Didn't Hear anything about Pulling Battery or Filter Replacement or Air Box Pulling ???

View attachment 5714