[tommypenguin]

Here's a diy on the UR ultra racing strut bar along with a short term review of it. Fort hr money and level of effort needed to install it don't think you can go wrong.

 

[tommypenguin]

Thanks for sharing. That looks like a mod I could do w/o screwing it up. 😁

About as easy as it gets, though I should have marked where the strut nut was when loosening the top to not change the camber.

107 with the door closed??!!

The Best Swamp Coolers for Garage - Consumer Reviews - The Ozone Hole

The Best Swamp Coolers for Garage - Consumer Reviews - read our comprehensive article on The Ozone Hole! ✅

theozonehole.com

Thanks as always for the vids/info!

That was at 9pm, got up to 109 in the garage earlier.

Hey dude...what is the part number...and where did you get it from?

Part number is UR-TW2-4159.

 

[tommypenguin]

Follow up this has been a really good mod. Highly recommended.

 

[tommypenguin]

Sorry I hadn't answered in the way previously you would like. Assumed you were just wanting to know if I had regrets or change in opinion with some more seat time.

Specifically, based on my setup with a rear sway bar and being lowered on a prokit with front power bar, I had some oversteer prior. The front bar has helped noticeably remove the oversteer. That is the biggest positive change I've gotten out of the mod.

There are no negatives in noise, vibration or harshness. Steering doesn't feel different for snappy cuts of the wheel, though that is one scenario I didn't baseline and rarely do. Hope that helps.

 

[tommypenguin]

Was noticeable prior, most obvious when making a direct right turn at speed. Wasn't bad by any stretch but there. Has diminished noticeably after the strut bar.