2018 Honda Accord Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter #1
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4". Just bought this hitch and I am going to install today. I’m not going to tell anything I just want to a bike rack on so I don’t scratch the paint on the hitch is that mount on the trunk lid. The installation don’t look bad just remove the rear bumper and bolt it on. Takes an hour to do. It did take a while to convince my wife to let me do this!
 

·
Registered
Joined
·
41 Posts
Discussion Starter #2
It’s installed. I do like the appearance! Wife even likes it!!?
I found the option of trimming the bumper is not really optional at all.. I had to get my torch out Ant heat the pocket knife to red hot ant cut the plastic bumper like butter without having to remove the bumper to trim it.
 

·
Registered
Joined
·
1 Posts
Drawtite Installation

I'm trying to install the Drawtite Hitch and am having trouble removing the bumper cover. Have removed all visible screws and clips but cover still will not come off. Are there some sort of clips under the tail lights holding it on? Is removing it different than what videos show for the 2017. Any tips you can give me would be greatly appreciated. Thanks!
 

·
Registered
Joined
·
39 Posts
In the video, etrailer shows room between the facia and tongue.
Does the facia have to be cut for draw tite performance hitch on non-hybrids?

I’m considering a simple diffuser.
 
1 - 4 of 4 Posts
Top