2018 Honda Accord Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Just wondering if anyone has installed Megan racing lowering springs on there 18? Any info on quality part/ride and if you like the amount of drop how it compares to eibach?
Thanks
 

·
Registered
Joined
·
662 Posts
Great Stuff - Nice Work




Great Details Very Nice Work



Off Set on those ( are those 8" Wide Rims ) Sits Nicely ~ Good Looks ~ Any Bit of Rubbing during Hard Corning & Bumps ?






Thank You for this Very Well Edited Video also .. 5 Stars ~ Top Notch ~ I'm still smiling :grin:
 

·
Registered
Joined
·
6 Posts
Discussion Starter #6
In case anyone else is wondering, I’ve had them installed for a couple weeks now and the car sits nice just what I wanted! Rides a little firmer than stock but not bad at all
 

·
Registered
Joined
·
16 Posts
In case anyone else is wondering, I’ve had them installed for a couple weeks now and the car sits nice just what I wanted! Rides a little firmer than stock but not bad at all
Hey, how is the car with the springs? I want to lower it too but nothing crazy and was thinking about these. It just sits a little too high for me from the factory.
 

·
Registered
Joined
·
21 Posts
Thought I’d share mine in case others are researching....
2019 Touring 2.0
D2 Pro 2” drop lowering springs
CONCEPT ONE - RS-55 (20" x 8.5" +35)
235/35R20 Tires
There is a bit of a gap in the back. Going to try 3/4” spacers. However, I want to add a rear camber kit before I do that.

I would have loved to do coil overs, but with the touring Adaptive Suspension, not much of an option unless you don’t mind staring at a suspension warning light on your dash for the rest of the time you own it. The ride has a small amount of bounciness. If I put it in sport mode it kills a bit of the bounciness.
IMG_1915.jpg
 

Attachments

·
Registered
Joined
·
21 Posts
Anyone else experiencing clunking noises from the front end after putting in Megan springs?
I do not have the Megan’s, I do have the D2 pros. My front left makes a light knocking noise going over bumps etc. Been working with tech-support at D2, however all of their suggestions have made no difference. Cannot figure out what the **** is making the noise. Just an FYI for anyone doing research etc.
 
1 - 12 of 12 Posts
Top