2018 Honda Accord Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Just trying to find out what all I need to install the prl fk8 inlet on the factory turbo. I have the inlet, prl install kit, conversation hose for hvi, p2r gasket ( because the gasket style on my 2021 was a different o-ring style when I removed the factory inlet) I'm guessing I'll need a downpipe? which I was planning on doing sooner or later.
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
You need a down pipe to be able to move the O2 sensor to the downpipe, you also need 1/2” coolant hose and a 1/2 splicer to tap it into the other end of rubber coolant hose. You will also need a new set of screws for the inlet (you can’t reuse the ones you remove to long). You can purchase the oem civic type r inlet screws. View attachment 7305
Thank you I appreciate the help man!!
 

·
Registered
Joined
·
7 Posts
You need a down pipe to be able to move the O2 sensor to the downpipe, you also need 1/2” coolant hose and a 1/2 splicer to tap it into the other end of rubber coolant hose. You will also need a new set of screws for the inlet (you can’t reuse the ones you remove to long). You can purchase the oem civic type r inlet screws. View attachment 7305
You need a down pipe to be able to move the O2 sensor to the downpipe, you also need 1/2” coolant hose and a 1/2 splicer to tap it into the other end of rubber coolant hose. You will also need a new set of screws for the inlet (you can’t reuse the ones you remove to long). You can purchase the oem civic type r inlet screws. View attachment 7305
Do u know the part number for inlet screws?
 

·
Registered
Joined
·
24 Posts
You need a down pipe to be able to move the O2 sensor to the downpipe, you also need 1/2” coolant hose and a 1/2 splicer to tap it into the other end of rubber coolant hose. You will also need a new set of screws for the inlet (you can’t reuse the ones you remove to long). You can purchase the oem civic type r inlet screws. View attachment 7305
Don't the prl installation kit come with all the screws required and all the hoses too
 

·
Registered
Joined
·
24 Posts
You need a down pipe to be able to move the O2 sensor to the downpipe, you also need 1/2” coolant hose and a 1/2 splicer to tap it into the other end of rubber coolant hose. You will also need a new set of screws for the inlet (you can’t reuse the ones you remove to long). You can purchase the oem civic type r inlet screws. View attachment 7305
Also what did u do to the vacuum line on the left did u plug it at the other end by mani
 
1 - 6 of 6 Posts
Top